E-Catalog > STANDSTILL MONITORING PILZ > Standstill monitoring # S1SW P

PAGE VIEW : 5,534

Product Information :

Name :
Standstill monitoring # S1SW P
Category :
  1. ไฟฟ้าและอิเล็กทรอนิกส์
Sub - Category :
  1. STANDSTILL MONITORING PILZ
Brand :
PILZ
Model :
S1SW P # 407710
Product Type :
  1. สินค้า, ผลิตภัณฑ์
Short Description :
S1SW P 24-240VACDC UM 0-690VAC/DC Product number: 407710 Product version: 1.2 Approvals: CE, UL/cUL, CCC Application options: Standstill monitoring Supply voltage: 24 - 240 V Supply voltage type: AC/DC Supply voltage range: 24 - 240 V Terminal type: Screw terminal Operating modes: Normally de-energised mode Width dimension: 22.5 mm Height dimension: 94.0 mm Depth dimension: 121.0 mm Gross weight: 155 g Net weight: 147 g Ambient temperature: -10 - 55 °C

Product Detail :

 
Standstill monitoring
S1SW P
The S1SW P standstill monitoring relay is used to monitor standstill on DC and
three-phase motors.
Approvals
Unit features
- Standstill monitoring with and with-out rundown time
- Standstill threshold can be set Run-down monitoring time can be set
- Normally de-energised mode
- Measuring circuits are galvanically isolated
- No speed sensor is required
- Suitable for use with a frequency converter
Description
The standstill monitoring relay is en-closed in an S-99 slimline housing with
plug-in terminals.
Features:
Relay outputs:
Standstill: 1 auxiliary contact (C/O)
Fault: 1 auxiliary contact (C/O)
Operating modes:
– Standstill monitoring without rundown monitoring
– Standstill and rundown monitoring
- Potentiometer to adjust the switch on threshold and monitoring time
- Slide switch to double the measuring range
- LEDs for relay's switch status, fault status and supply voltage
- The S1SW P monitors the rundown on a three-phase asynchronous machine
with standstill detection. The regenerated voltage induced from the motor is
measured; standstill is signalled (relaycontact) if the value falls below a set threshold. A second relay signals a fault if the voltage does not fall below the set threshold within the set run-down monitoring time. The time measurement is started by closing a volt-free start contact (N/C contact on the motor contactor at Y3, Y4). The slide switches can be used to switch the measuring ranges.